Dynamic Weighing - Uline Ohaus Defender 5000 Mode D'emploi

EDITING THE UNDER SETTING
1. The display shows SEt.LO. Press the
YES button to edit setting.
Settings:
-999950 to 999950
Refer to Menu Navigation to
enter settings.
NOTE: The minus sign is used
together with the first digit to
show a negative value.
EDITING THE OVER SETTING
1. The display shows SEt.HI. Press the
YES button to edit setting.
Settings:
-999950 to 999950
Refer to Menu Navigation
to enter settings.
BEGIN CHECK WEIGHING
The appropriate under, accept or over
LED lights indicate check weigh status.
1. Place a sample on the scale and
read the weight.
2. For loads less than the under limit,
the yellow under LED is lit.
3. For loads greater than the under
limit and less than the over limit, the
green accept LED is lit.
4. For loads greater than the over limit,
the red over LED is lit.

DYNAMIC WEIGHING

Use this mode to weigh moving or
oversized objects. The weight is held
on the display until reset. Manual,
semi-automatic and automatic start/
stop methods are available.
BEGIN DYNAMIC WEIGHING
1. When the display shows rEAdY,
place the object on the scale.
2. If the manual mode is in use, press
the FUNCTION MODE button to start measurement.
If the semi-automatic or automatic mode is in use,
measurement is started automatically.
PAGE 8 OF 32
OPERATION CONTINUED
SEt.LO SEt.LO
kg
kg
to
kg
SEt.HI SEt.HI
kg
3. When the countdown has
kg
4. If the manual or semiautomatic
  . . O.000
kg
5. If the automatic mode is in use,
. . O.123
kg
6. The scale is now ready to accept a new object.
. 1 . 1 1 1 1.234 1.234
kg
LEGAL FOR TRADE
When the indicator is used in trade or a legally
controlled application, it must be set up, verified and
sealed in accordance with local weights and measures
. . 122.345 122.345
kg
regulations. It is the responsibility of the purchaser to
ensure that all pertinent legal requirements are met.
SETTINGS
Before verification and sealing, perform the following steps:
dYNA dYNA
kg
1. Verify that the menu settings meet the local weights
2. Perform a calibration.
3. Set Legal for Trade to ON in the Setup menu.
4. Without exiting the menu, turn the indicator off.
5. Disconnect power from the indicator and open the
rEAdY rEAdY
6. Set the security switch to ON.
7.
8. Reconnect power and turn the indicator on.
NOTE: When using manual
mode, it is not necessary
for the display to be at zero
gross or net. When using
semi-automatic or automatic
mode, the display must be
at zero gross or net before
placing the object on the
scale. The example is for a
setting of 5 seconds. During
the averaging period, the
countdown timer decreases in
one second increments.
NOTE: If SEt 0 was selected in
the Dynamic menu item, the
countdown timer is not displayed.
completed, the readings are
averaged and held on the display.
The averaged weight is displayed
until rest.
mode is in use, reset the countdown
timer by pressing the FUNCTION
MODE button. Then the display
shows rEAdY.
the held reading is shown on
the display for 10 seconds after
the object is removed to within 5
divisions of zero. Then the display shows rEAdY.
and measures regulations.
housing.
Close the housing.
5 SEC 5 SEC
1 SEC 1 SEC
. . 1.234
1.234
kg
~
. . 1.234
1.234
kg
~
rEAdY rEAdY
0921 IH-4595