Turning Indicator On/Off; Menu Navigation - Uline Ohaus Defender 5000 Mode D'emploi

1. Remove red shipping tags located under metal pan.
(See Figure 1)

TURNING INDICATOR ON/OFF

1. To turn the Indicator on, press the
ON/ZERO OFF button. The Indicator
performs a display test followed by
a series of informational displays
and then enters the active weighing mode.
2. To turn the Indicator off, press and hold the ON/ZERO
OFF button until OFF is displayed.

MENU NAVIGATION

TO ENTER THE MENU MODE
1. Press the TARE MENU button until
MENU is displayed. When the button
is released, the Legal for Trade status
is displayed, followed by the first
menu.
YES Allows entry into the displayed menu.
Views menu item setting.
Accepts the displayed setting.
Skips by the displayed menu.
NO/BACK
Rejects the displayed setting and
advances to the next available item.
EXIT Exits from menu directly to the current
application.
2. For menu items with numeric settings
such as Capacity, the current setting
is displayed with all digits flashing.
Press the NO button to begin editing.
3. The first digit is displayed flashing.
4. Press the NO button to increment
the digit or press the YES button to
accept the digit and move to the
next digit.
5. Repeat this process for all digits.
PAGE 2 OF 32
SET UP
OPERATION
6. Press the YES button when the last
7. The new setting is displayed with all

8. This method also applies to setting Check Weigh
9. For End menu items, pressing the YES button
CHANGE UNIT OF MEASURE
MENU
SET UNIT OF MEASURE AT STARTUP
Set the unit of measure displayed at startup to g, kg, lb., oz.,
lb:oz, t, c (custom unit) or Auto (last unit in use when power
was turned off).
1. Once in the Setup Menu, press No
2. Press Yes to enter the POWER ON UNIT setting.
3. Press No until the desired unit of measure is displayed.
4. Press Yes to accept the new unit of measure.
000000 000000
0 0 00000
1 1 00000
Figure 1
digit has been set.
digits flashing. Press the YES button
to accept the setting or press the NO
button to resume editing.
under and over targets.
advances to the next menu, while pressing the NO
button returns to the top of the current menu.
until the POWER ON UNIT setting is
displayed.
NOTE: Units oz, lb:oz and C (custom) will not be
valid as Power On units when Range is set to
Dual. The next available unit will be displayed
instead.
NOTE: Default set to auto.
100000 0
100000 100000
0921 IH-4595