Operation - VALBERG DC 8 B W566C Consignes D'utilisation

B
Using the appliance

Operation

Quick operation
NOTE :
Before use, ensure that the appliance is correctly installed.
1
Plug in
Dry
Switch on Program Select the
selection default function
or mode
After drying
The alarm sounds or the message "0:00" is displayed.
1. Open the door and take out the laundry
2. Remove the tank
3. Empty the condensation water
4. Clean the filter
5. Switch off the power
NOTE : If you use a switch, press the button to switch off the
power directly.
2 3
Load Close the door
Start
8 EN
B
Using the appliance
CAUTION : Before the very first cycle, there may still be
some of the grease or dust generated during manufacturing
or transportation inside the dryer. To avoid contaminating
your laundry, follow these instructions:
• Load some clean cloths into the drum.
• Plug in the appliance.
• Select the "Fast" program and press the "Start/Pause"
button.
• Once this program is finished, follow the instructions in
the "Cleaning and Maintenance" section to clean the lint
filter and condenser.
1. Before you start drying, make sure your clothes have been spun in the washing machine. High-
speed spinning reduces drying time and saves energy.
2. To ensure that your clothes dry evenly, sort your clothes according to the type of fabric and the
correct drying program.
3. Before drying, close zips, hooks or eyelets, button your clothes and fasten fabric belts, etc.
4. Do not over-dry your clothes; excessive drying may crease your laundry.
5. Do not dry laundry containing rubber or any other similar elastic material.
6. The door can only be opened if the dryer has finished the current cycle. This is to avoid any
burns from the hot surfaces of the machine or condensation.
7. Clean the lint filter and always empty the tank after use to avoid any increase in drying times
and energy consumption.
8. Never put dry-cleaned clothing in the dryer.
Reference weight for dry clothing (per unit)
9 EN