Honeywell RCA902N Directives D'installation page 18

Installation Instructions
The DUSK control determines how dark it needs to be before detected movement will
trigger the controlled lights and can be set as follows:
2) Turn the DUSK control knob to the
3) When the ambient light level reaches the level at which you wish the lights to
turn on (i.e. at dusk), SLOWLY turn the control in a clockwise direction towards
the mark until movement causes the light(s) to illuminate. Leave the control
set at this point.
4) The motion detector will become operative at approximately the same level of
darkness each evening. Observe the operation of the unit over several nights to
ensure it is set as required and adjust as necessary. If the unit activates too early
(i.e. when it is too light), turn the control slightly towards the
activates too late (i.e. when it is too dark), turn the control slightly towards the
mark.
69-2157EFS—05
69-2157EFS_C.indd 16
setting and wait until darkness falls.
16
mark. If the unit
9/22/2008 11:54:04 AM