Break-In Of The Pump - MasterCraft 058-1290-6 Guide D'utilisation

14
model no. 058-1290-6 | contact us 1-800-689-9928

BREAK-IN OF THE PUMP

•
Turn the pressure switch to the OFF position (B, Fig. 4).
•
Open the petcock (C, Fig. 4).
•
Plug in the power cord.
•
Turn the pressure switch to the AUTO position (A, Fig. 4). The compressor will
start. Allow the compressor to run for 30 minutes, to break in the internal
parts.
•
NOTE: After about 30 minutes, if the unit does not operate properly, SHUT
DOWN IMMEDIATELY, and contact customer service.
•
After about 30 minutes, turn the pressure switch to the OFF position.
•
Close the petcock (D, Fig. 4).
•
Turn the pressure switch to the AUTO position. The compressor will start and
fill the tank to the kick-out pressure and stop.
•
NOTE: As compressed air is used, the pressure switch will restart
the motor automatically.
headline bars headline bars
continuation tabs continuation tabs
notes notes
warnings warnings
Fig.4
A
B
C
OPEN
D
CLOSED