Adjusting The Sound - Sony SA-VA10 Mode D'emploi

Masquer les pouces Voir aussi pour SA-VA10:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Home Theatre Operations
Note
Pressing buttons other than MASTER VOL., RESET,
CENTER +/–, REAR +/–, or BALANCE L/R cancels the test
tone.
Adjusting the delay time
By adjusting the delay time you can enhance the spatial
characteristics of the sound to obtain a theatre-like
presence regardless of the size of your room. If the rear
speakers are close to your listening position, choose a
longer delay time.
You can adjust the settings individually for DOLBY
SUR, HALL and GAME.
Note
The delay time cannot be adjusted in PRO LOGIC 3CH
mode.
1
Choose any surround mode.
2
Playback a program.
3
Press DELAY on the remote once to display the
current delay time.
4
Press DELAY a few times to choose the delay time
you prefer, either 15, 20, or 30 ms.
The factory setting is 20 ms.
To restore the delay time to the factory setting
Press DELAY and then RESET.
Resetting an entire surround mode
Press the button for the surround mode you want to
reset (i.e., HALL) and then press RESET while the
name of the surround mode is being displayed.
All of the adjustments in that mode, including the bass
and treble, are reset to the factory settings.
GB
12

Adjusting the Sound

Although this speaker system's sound quality is
already adjusted. You can change the settings, as you
like, for each surround mode individually. The
following settings remain stored in their respective
surround mode until you change them.
+
+
+
+
BASS +/–
BALANCE L/R
1
Playback a program and choose a surround mode.
2
Make the following sound adjustments according
to your preference and/or the type of program
you are watching.
To
press
adjust the super
S.WOOFER + or –
woofer level
adjust the bass level
BASS + or –
adjust the treble level
TREBLE + or –
adjust the balance
BALANCE L or R*
* Since BALANCE L and R control sound from the front
speakers, they have little effect on DOLBY SUR when the
source software has a high proportion of centre-channel
sound.
To restore the factory settings
Press RESET after pressing either S.WOOFER +/–,
BASS +/–, TREBLE +/–, or BALANCE L/R.
+
S.WOOFER +/–
TREBLE +/–
SUPER WOOFER
MODE (1, 2, OFF)

Publicité

Table des Matières
loading

Table des Matières