Memorizing Channels - Nyrius NY-LED1980N Guide De L'utilisateur

MEMORIZING CHANNELS

This TV is equipped with a channel memory feature which allows channels to skip up or down to the
next channel set into memory, skipping over unwanted channels. Before selecting channels, they must
be programmed into the TV's memory. To use this TV with an antenna, set the Signal Type option to the
Air mode. When shipped from the factory, this menu option is in the Cable mode.
Air/Cable selection
1. Select "Channel", then press
2. Press ▲ or ▼ to select "Auto Ch Memory", then press
or ENTER.
3. Press ▲ or ▼ to select "Signal Type".
4. Press or to select "Air" or "Cable".
CABLE CHART
The chart below is typical of
many cable system channel
allocations.
Note:
• It may take a few
seconds for a digital
channel picture to
appear on screen
after being selected.
Automatic Search
1. Select "Channel", then press
2. Press ▲ or ▼ to select "Auto Ch Memory", then press
3. Press ▲ or ▼ to select "Automatic Search", then press
4. The TV will begin memorizing all the channels available in your area.
• It may take from 15 minutes to 30 minutes to complete memorizing
digital cable channels. Depending on the reception condition, a bar
display may not advance for several minutes, please be patient.
Note:
• Memorizing channels is best accomplished during evening "PRIMETIME" hours, as more stations
are broadcasting digital signals. Memorizing channels can only be accomplished while a station is
broadcasting a digital signal to set that channel into memory.
• If you are unsure of the digital channels available in your area, you may visit www.antennaweb.
org to receive a list based on your address or zip code. Should you require further assistance you
may call our toll-free customer service line at 1-800-663-5954.
• New digital channels may be added to your area periodically, it is recommended to perform the
"Automatic Search" procedure regularly.
Adding Channel
If you find a new digital channel unregistered, you can add the new
channel into the channel memory.
1. Tune in the new channel.
2. Select "Channel", then press
3. Press ▲ or ▼ to select "Add/Delete", then press
4. Press ▲ or ▼ to select "Adding Channel", then press
The new channel will be added into the channel memory.
Add/Delete channel
You can select the channel that you want to skip.
1. Select "Channel", then press
2. Press ▲ or ▼ to select "Add/Delete", then press
3. Press ▲ or ▼ to select the channel that you want to skip.
4. Press or to select "Add" or "Delete", whichever function you
want to perform.
5. Repeat steps 4 - 5 for other channels you want to add or delete.
All manuals and user guides at all-guides.com
or ENTER
or ENTER
or ENTER.
or ENTER.
- 18 -
or ENTER.
or ENTER.
or ENTER.
or ENTER.
or ENTER.