Nyrius NY-LED1980N Guide De L'utilisateur page 13

CONNECTIONS TO OTHER EQUIPMENT
Using an AV Amplifier with built-in digital surround
If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems
including Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, etc. as shown below.
NOTE:
• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or
MPEG audio. There will be no sound output if connected to an AV amplifier with a built-in DTS
decoder or MPEG decoder.
To connect the TV to a PC (Personal Computer)
BEFORE YOU CONNECT THIS TV TO YOUR PC, CHANGE THE ADJUSTMENT
OF YOUR PC'S RESOLUTION AND REFRESH RATE (60 HZ).
Connect one end of a (male to male) VGA cable to the video cord of the computer and the other end to
the VGA connector PC MONITOR on the rear of the TV. Attach the connectors firmly with the screws
on the plug. In case of a Multimedia computer, connect the audio cord to the audio output of your
Multimedia computer and to the AUDIO connector of the PC/DVI AUDIO IN jack of the TV. You can also
connect the PC with HDMI cable. If you use HDMI cable, you don't have to connect the audio cord. If
you use DVI-to-HDMI cable, please connect audio cord as same way as VGA cable.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The TV can operate as the computer monitor.
NOTE:
• The on-screen displays will have a different appearance in PC mode than in TV mode.
• If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the
TV-screen.
All manuals and user guides at all-guides.com
- 13 -
Monitor Display modes
MODE Resolution
VGA 640x480
VGA 720x400
SVGA 800x600
XGA 1024x768
WXGA 1280x768
WXGA 1280x720
WXGA 1360x768
To return to normal mode
Press INPUT SELECT again.
Refresh rate
60/72/75 Hz
70Hz
56/60/72/75 Hz
60/70/75 Hz
60Hz
60Hz
60Hz