Starting Setup; Tv Operation - Nyrius NY-LED1980N Guide De L'utilisateur

The Starting Setup menu appears the first time you turn on the TV, and assists you to specify the Air/
Cable setting, and program your channels
automatically.
IMPORTANT: Make sure that the antenna or cable TV system connection is made!
1. To turn on the TV, touch
of the unit changes blue.It may take approx. 10 seconds for a picture
to appear on screen.). The starting setup function begins.
2. Press or to select "Cable" or "Air".
3. Press ▲ or ▼ to select "Automatic Search", then press
ENTER.
4. "Auto Setup" will begin. After the starting setup is completed, the TV
channel appears on the screen.
• Depending on the reception condition, it may take up to 30
minutes to complete memorizing digital cable channels. Please
allow the process to complete without interruption.
NOTE:
• If you press ENTER in the process of "Auto Setup", the Starting Setup stops and changes to the
normal screen.
• When you make a menu selection, your changes occur immediately. You do not have to press EXIT
to see your changes.
• When you are finished programming the menus, press EXIT.
1. To turn on the TV, touch
may take approx. 10 seconds for a picture to appear on screen.)
2. Adjust the volume level by pressing VOL + or – . The volume level will be indicated on the screen
by blue bars. As the volume level increases, so do the number of bars. If the volume decreases, the
number of blue bars also decreases.
3. Set the Signal Type option to the appropriate position.
4. Press the Direct Channel Selection (0-9, –) buttons to select the channel. (If you press only channel
number, channel selection will be delayed for a few seconds.)
TO SELECT ANALOG CHANNELS
1-9: Press 1-9 as needed. Example, to select channel 2, press 2, then press ENTER.
10-99: Press the 2 digits in order. Example, to select channel 12, press 1, 2, then press ENTER.
100-135: Press the 3 digits in order. Example, to select channel 120, press 1, 2, 0, then press ENTER.
TO SELECT DIGITAL CHANNELS
Press the first 1-3 digits, then press the – button, followed by the remaining number.
Example, to select channel 15-1, press 1, 5, –, 1, then press ENTER.
• If a channel is selected with only audio content, "Audio only" will be displayed on the screen.
• If a channel is selected with a weak digital signal, "Digital channel signal strength is low" will be
displayed on the screen. The same program may be available on either an analog channel or a
digital channel. You may choose to watch either format.
• If a channel is selected to which you have not subscribed, "Digital channel is encrypted" will be
displayed on the screen.
VHF/UHF/CABLE CHANNELS
Air
VHF
2-13
UHF
14-69
All manuals and user guides at all-guides.com

STARTING SETUP

(POWER) (POWER indicator on the front

TV OPERATION

(POWER). (POWER indicator on the front of the unit changes blue. It
NOTE:
Cable
•
VHF
2.13
•
STD/HRC/IRC
2.13 (A)(W)
37-59 (AA)(WW)
60-85 (AAA)(WWW)
86-94 (86)(94)
95-99 (A-5)(A-1)
100-135 (100)(135)
01 (4A)
- 15 -
or
If a channel with no broadcast is selected,
the sound will automatically be muted.
It may take a few seconds for a digital
channel picture to appear on screen after
being selected.