Exo Terra WATERFALL PT-2905 Mode D'emploi page 4

6. Disconnect the plug of this and any other submersed appliance before placing hands in the water.
7. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less
amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so
that it will not be tripped over or pulled.
8. Read and observe all the important notices on the appliance.
9. Do not use this appliance for other than its intended use. The use of attachments not recommended or
sold by the appliance manufacturer may result in a dangerous situation.
10. Do not install or store the appliance where it will be exposed to the weather or to temperatures below
freezing.
11. Do not expose the appliance under sunlight or place at low temperature for a long period of time.
12. Make sure the appliance is securely installed before operating it.
13. The pump must be immersed in water. The pump must not run dry.
14. A. GROUNDING INSTRUCTIONS (for USA only): This appliance should be grounded to minimize the
possibility of electric shock. This appliance is equipped with an electric cord having an equipment
grounding conductor and a grounded type plug. The plug must be plugged into an outlet that is
installed and grounded in accordance with all appropriate codes and ordinances.
B. WARNING (for Canada only): This appliance has a polarized plug (one blade is wider than the
other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with
an extension cord unless plug can be fully inserted. Do not attempt to defeat this safety feature.
Save these instructions.
15.
The Exo Terra Waterfall is powered by the Exo Terra Repti Flo 200 Circulation Pump (included). The
pump is for indoor, household use only and is designed to power a variety of aquarium appliances that
require a submersible circulating pump such as terrarium waterfalls, circulating water parts, etc. The
pump is hermetically sealed to ensure safety and a long lasting life. Since it does not employ older
technologies requiring oil cooling, it can never leak or contaminate the area with coolant. This pump is
not recommended or designed to transport corrosive or flammable compounds or liquids with different
properties than water. The pump motor is hermetically sealed with all live electrical parts immersed in
a protective casing to prevent total insulation against water damage and electrical shock. The motor is
4 extremely compact and energy efficient, while at the same time producing a continuous output flow.`
Installation:
1. a) Small Waterfall: Insert pump into back of waterfall. Press down firmly on the pump to ensure the
suction cups on the bottom of pump fully secure the pump in place. Attach the pump to the waterfall
output tube. b) Medium/Large Waterfall: Attach the pump to the waterfall output tube. Fit the waterfall
into the base; adjust the pump so that it is positioned flat on the base's interior. Press down on pump to
ensure suction cups are holding it firmly in position.
2. Fill the waterfall basin with enough water to cover the pump.
3. Position the collection tank, back cover (small waterfall only), and rock pool (medium/large waterfall
only) in place. Medium/Large Waterfall: Note - If using an optional fogger, install the fogger in the
waterfall niche first before positioning the rock pool.
4. Arrange waterfall in position in terrarium. Waterfall should be placed on a flat, level surface.
5. Plug in unit. If the unit does not start immediately, verify that the water level is sufficient to immerse
pump during operation. If problem persists, see the "Trouble-shooting" and "Maintenance" sections
of this manual for further information.
A B
C