Product Description - Fracarro OPT-TX51 Instructions D'emploi

The optical transmitter (OPT-TX51) and the optical receiver (OPT- RX51) for the distribution of satellite and terrestrial signals
through a single cable of mono-modal fibre optics. The signals of the four satellite polarizations and the terrestrial signal are
transmitted.
The two modules also transmit an auxiliary upgrade channel for the transmission/reception of data or audio/video signals.
The upgrade channel needs external devices that use a wavelength within the range of 1260 ÷ 1500nm.
This solution allows one to distribute the TV (PAL(*) and COFDM) and the IF satellite band onto a single link in a mono-modal
fibre optics.
(*) to measure the installation with analog signals, see table 4 on page 19.
1. ON LED
1. LED DI
2. ALARM
ACCENSIONE
LIGHT
LED
5. OUT (SAT-TV
5. OUT: LINK
OTTICO SAT-TV
OPTICAL LINK)
2. OUT (SAT-TV
2. INT: LINK
OTTICO SAT-TV
OPTICAL LINK)
1. ALARM
LED
IN
4. SAT OUT

2. PRODUCT DESCRIPTION

4. TERR:
TV IN
3. SAT IN
TERR
OPT-TX51
OUT AUX
6. AUX in/out (OPTICAL
6. AUX in/out: LINK
OTTICO CANALE LINK OF THE
AUSILIARIO
AUXILIARY CHANNEL)
3. AUX in/out (OPTICAL
3. AUX in/out: LINK
LINK OF THE
OTTICO CANALE
AUXILIARY CHANNEL) AUSILIARIO
AUX
OPT-RX51
TERR
5. TERR:
TV OUT
1. ON LED LIGHT: the LED shows that the
7. GROUNDING
7. VITE DI MESSA
OPT-TX51 optical transmitter is ON.
A TERRA
SCREW
2. ALARM LED: the alarm LED shows that
the transmission laser is not working properly.
3. SAT IN: the IF input connectors of the 4
satellite polarizations (950 ÷ 2200MHz).
4. TERR (TV IN): F input connector of the TV
signal (47 ÷ 862MHz).
5. OUT (SAT-TV OPTICAL LINK): SC-APC
output connector of the optical transmitter.
Used for the link with fibre optics of the signals
of the satellite polarizations and TV signals.
6. AUX in/out (OPTICAL LINK OF THE AUX-
ILIARY CHANNEL): SC-APC input/output
connector of the optical transmitter. Used for
the link with fibre optics of the auxiliary chan-
nel, if any.
7. GROUNDING SCREW
1. ALARM LED: alarm LED, which indicates
that the input optical power is too low.
2. IN (SAT-TV OPTICAL LINK): SC-APC in-
put connector of the optical receiver. Used for
the link with fibre optics of the satellite polari-
zation signals and TV signals.
3. AUX in/out (OPTICAL LINK OF THE
AUXILIARY CHANNEL): SC-APC input/out-
put connector of the optical receiver. Used for
the link with fibre optics of the auxiliary chan-
nel, if any.
4. SAT OUT: F output connectors of the 4
satellite polarizations (950 ÷ 2200MHz).
5. TERR (TV OUT): F output connector of the
TV signal (47 ÷ 862MHz).
6. GROUNDING
6. VITE DI MESSA
SCREW
6. GROUNDING SCREW
A TERRA
16
.
.