Product Description; Product Installation - Fracarro OPT-TX54 Instructions D'emploi

The optical transmitter (OPT-TX54) and the optical receiver (OPT-RX54) for the distribution of satellite and terrestrial signals
through a single cable of mono-modal fibre optics. The signals of the four satellite polarizations and the terrestrial signal are
transmitted. This solution allows one to distribute the TV (COFDM) signals and the IF satellite band onto four mono-modal
fiber-optic cables.
2. ALARM
1. ON LED 1. LED DI
LED
ACCENSIONE
LIGHT
1. ALARM
LED
Both the (OPT-TX54) transmitter and the (OPT- RX54) receiver can be fixed to the wall with the proper plastic supports.
We recommend to connect all the input and output cables before powering the modules in order to avoid damaging the
transmitter laser or the receiver photodiodes.
The optical transmitter (OPT-TX54) must be connected to the 230 VAC power supply network.
The optical receiver (OPT- RX54) must be remotely powered by one of the four satellite inputs (maximum absorption of the
receiver: 240mA @ 14V).

2. PRODUCT DESCRIPTION

4. TERR:
TV IN
3. SAT IN
V/L H/L V/H H/H TERR
OPT-TX54
OUT1 OUT2 OUT3 OUT4+TERR
5. OUT (SAT-TV
5. OUT: LINK
OTTICO SAT-TV
OPTICAL LINK)
2. IN (SAT-TV
2. IN: LINK
OPTICAL LINK)
OTTICO SAT-TV
IN1 IN2 IN3 IN4+TERR
OPT-RX54
V/L H/L V/H H/H TERR
3. SAT OUT
4. TERR:
TV OUT

3. PRODUCT INSTALLATION

6. GROUNDING
6. VITE DI MESSA
A TERRA
SCREW
5. GROUNDING
5. VITE DI MESSA
SCREW
A TERRA
14
1. ON LED LIGHT: the LED shows that the
OPT-TX54 optical transmitter is ON.
2. ALARM LED: the alarm LED shows that the
transmission laser is not working properly.
3. SAT IN: the IF input connectors of the 4
satellite polarizations (950 ÷ 2200MHz).
4. TERR (TV IN): F input connector of the TV
signal (47 ÷ 862MHz).
5. OUT (SAT-TV OPTICAL LINK): SC-APC
output connector of the optical transmitter.
Used for the link with fibre optics of the signals
of the satellite polarizations and TV signals.
6. GROUNDING SCREW
1. ALARM LED: alarm LED, which indicates
that the input optical power is too low.
2. IN (SAT-TV OPTICAL LINK): SC-APC input
connector of the optical receiver. Used for the
link with fibre optics of the satellite polarization
signals and TV signals.
3. SAT OUT: F output connectors of the 4
satellite polarizations (950 ÷ 2200MHz)
4. TERR (TV OUT): F output connector of the
TV signal (47 ÷ 862MHz).
5. GROUNDING SCREW
.
.