Safety Measures - Kemper 3030N Mode D'emploi

8. The appliance has not been designed for use by people (children included) with reduced mental,
physical or sensorial capacities or those without experience or knowledge, unless they have
benefited from supervision or instructions in its use through the intermediation of a person
responsible for their safety. Children must be supervised in order to make sure that they do not
play with the appliance.
9. If the power cord is damaged, have it replaced by the manufacturer or the manufacturer's
technical support service, or by an adequately qualified technician so as to prevent any risks.
10. Remove all the packaging material and make sure that the appliance is in good condition. If you
have any doubt, do not use the appliance and contact our After-Sales Service. Keep the
packaging material (staples, nylon bags, etc.) out of the reach of children. Before turning the fan
heater on, check that the voltage and frequency of the power socket are compatible with those
indicated in the product technical plate.
11. This appliance must be connected to an approved mains socket that complies with the safety
regulations on electrical systems for civil purposes. The electrical system must be specific for the
appliance rated voltage.
12. Never cover the appliance, as this could cause risk of overheating.
13. Store the tool far from rain or humidity.
14. The appliance must be used only for its intended use, that is soldering iron. Any use other than
its intended purpose shall be deemed to be improper and hazardous.
15. The manufacturer shall not be held responsible for damages derived from misuse of this
appliance.
16. To use this appliance in total safety implies observing some basic safety measures, such as:
never use the appliance with wet hands or feet, never expose the appliance to moisture or
water, never leave the appliance exposed to atmospheric agents, never disconnect the plug by
pulling the power cord or the appliance itself.
17. Always unplug the appliance before performing any maintenance and whether it is not used for
long periods of time. Before inserting or removing the tips, unplug the appliance.
18. The appliance has dangerous components that must be kept out of the reach of children.
19. The power cord must never be in contact with the hot surfaces of the soldering iron.
20. Never connect the power cord to extensions or triple plugs. Do not pull or damage the power
cord. Before any maintenance operations, disconnect the plug from the mains socket.
21. If the appliance does not work properly, immediately turn off the fan heater and disconnect it
from the mains socket. For repairs, contact a technical support centre authorised by the
manufacturer, and require that original spare parts be used. Using parts that do not conform to
the product may seriously compromise its correct operation.
22. Do not use the tool if any part is damaged or defective. The electricity supply wire cannot be
replaced. If the wire is damaged, the appliance must be scrapped.
23. This tool is not a toy.
24. Never use this device near curtains, inflammable material, furniture, etc.

SAFETY MEASURES

1. ATTENTION: Always place the solder on a flat and even surface.
2. Do not use the tool on devices or conductors under voltage.
3. Keep the tool away from inflammable materials. This tool can set fire to different materials,
make a proof on a discarded material before use.
4. Disorder and scarce lighting could cause incidents. Keep the working area always clean and well-
lighted.
DT istr. (3030N / 3035N / 3040N) 03/2012 REV 2 11/2013 5