Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User Manual -USA
Installation Instructions:
DO NOT INSTALL DURING ACTIVE
STORM CONDITIONS.
The SPD4coax is intended to provide
surge protection for customer premises
and
head
end
grounding per CEC code is required.
Failure to follow these instructions
can result in personal injury and/or
equipment damage.
Siemens Industry, Inc.
5400 Triangle Parkway
Norcross, GA 30092
888-333-3545
info.us@siemens.com
2
equipment.
Proper
Figure 1. Typical Cable Modem Installation
Figure 2. Typical Cable TV Installation
DC Voltage Breakdown Rating (100V/s):
150 - 300VDC
1. Properly ground the unit by connecting
grounding wire to ground screw on the
surge protector and the ground point
nearest to the incoming coax cable line.
2. Use the supplied coax cable extension line
(if necessary) to connect the incoming
cable service to side A of the SPD4coax
and connect side B to the equipment
being protected. (See Figure 1 or 2)
©2010 Siemens Industry, Inc.
All Rights Reserved. Siemens is a registered
trademark of Siemens AG. Product names
mentioned may be trademarks or registered
trademarks of their respective companies.
Specifications are subject to change without notice.
www.usa.siemens.com/spd
Publicité
Table des Matières
