Husqvarna CR 125 2010 Livret D'utilisation Et D'entretien page 93

The standard calibrations and the adjustment procedures are
shown below.
ADJUSTING THE COMPRESSION FORK
a) COMPRESSION (CR: UPPER REGISTER; WR: LOWER REGISTER)
Standard calibration: -9 clicks (CR)
Standard calibration: -10 clicks (WR)
Remove plug (B) and turn register (A) clockwise until the posi-
tion of fully closed is reached then, turn back by the men-
tioned clicks.To obtain a smoother braking action, turn the reg-
ister anticlockwise. Reverse the operation in order to obtain a
harder action.
b) EXTENSION (CR: LOWER REGISTER; WR: UPPER REGISTER)
Standard calibration: -13 clicks (CR)
Standard calibration: -10 clicks (WR)
To reset standard calibration turn register (C) clockwise to
reach the position of fully closed; then, turn back by the men-
tioned clicks. To obtain a smoother braking action, turn the
register anticlockwise. Reverse the operation in order to obtain
a harder action.
a)
A
c) AIR VENT (to carry out after each competition, or monthly).
Set the motorcycle on a central stand and release the fork fully
and loosen the air vent valve (D). Once this operation is over,
tighten the valve.
WARNING: Never force the adjusting screws
beyond the maximum opening and closure
positions.
b)
C
a)
D
WR
OIL FORK LEVEL
For the regular fork operation, both legs must be provided
with the necessary oil quantity.
WR: Remove the forkrods form the fork to check the oil level
inside the forkrods. Work as follows:
- remove the power rod caps;
- remove springs from the stems letting the oil drop into the
latter;
- bring forks to stroke end;
- check that the level is at distance "A" below the upper limit
of rods.
OIL QUANTITY IN EACH FORK LEG
-CR: 352 cm 3
D
-WR: 643 cm 3
NOTE
Flexibility index for the serial springs:
K=8,8 N/mm (CR)
K=8,4 N/mm (WR)
NOTE
Always replace both the spring and the spacers to keep the
preload value unchanged.
WR
b)
C
A
CR
CR
29