Universal Control Indicators (Led's) - gala gar D-GPS 5K Manuel Technique D'instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

3.2 UNIVERSAL CONTROL PANEL.

This section of the wire feeder panel, called "Universal Control", regulates the synergic control of the

equipment in such a way that we will carry out the actual welding adjustment and the necessary corrections for

customised adjustment.

Indication of thickness (flat welding)/thickness (angle welding/groove to weld (GMAW Process)

LD 3

regulation/display mode. The configuration of the desired type of thickness will be carried out from 3rd

setup level. If the throat and angle thickness have been set, LD1 will flash.

LD 4

Indication of welding current regulation/display mode.

LD 5

Indication of the wire speed regulation/display mode. (MIG process)

LD 6

Indication of arc length correction regulation/display mode (MIG Process).

LD 7

Indication of welding voltage regulation/display mode.

LD 8

Indication of welding dynamics correction regulation/display mode.

LD 9

Indication of pulse frequency regulation/display mode. (Pulsed TIG process)

LD 10

Indication of arc force percentage value in MMA.

LD 11

Indication of HOLD display (memorised parameters).

LD 12

Indication of globular transfer mode.

Selection of parameter (LD3÷LD5) to be regulated (E3)/display(D4).

Selection of parameter (LD6÷LD8) to be regulated (E3)/display(D4).

Bleed gas. The gas solenoid valve is activated whilst depressed. The solenoid valve activation is prolonged

(GAS)

for two seconds after pressing.

P10 (Wire)

Wire purge. The drive motor is activated whilst depressed. Wire speed according to VHI (level 3 setup)

PUSH

PUSH- - - - BUTTONS COMBINATIONS OF UNIVERSAL C

P7+P8

Enter/Exit to SETUP Mode

ADJUSTMENT MODE OF MANUAL MIG WELDING.

Wire speed adjustment (LD5). Adjustment display in D4.

ADJUSTMENT MODE OF SYNERGIC MIG WELDING.

ENCODER

Adjustment of selected parameter with P7 (LD3÷LD5). Adjustment display in D4.

MMA / TIG/ TIG PULSE WELDING MODE. Welding intensity adjustment. Display in D4.

SETUP MODE : Selection of SETUP variable (shown in D4),

ADJUSTMENT MODE OF MANUAL STANDARD GMAW WELDING PROGRAM

Adjustment of selected parameter with P8 (LD6÷LD8). Adjustment display in D5.

ADJUSTMENT MODE OF SYNERGIC GMAW WELDING PROGRAM

ENCODER

Adjustment of selected parameter with P8 (LD6÷LD8). Adjustment display in D5.

MMA WELDING MODE. Adjustment of Arc Force in % value to l2.

PULSED TIG WELDING MODE. Pulse frequency adjustment.

SETUP MODE : Variable value assignment (value shown in D5)

D-GPS 5 Kg