Husqvarna 591111501 Manuel Du Propriétaire page 6

6. To prevent contact of the left hand strap
with the EFM (Electronic Fuel Management)
box on the engine, place the foam strip
on the inside of the strap, next to the box.
(Illustration location is approximate.)
7. It may necessary to drill holes into the rear
guard to accept the hardware for the support
bracket and spacer plate. Using the bracket
as a template, drill 5/16" holes.
8. Place the spacer plate between the support
bracket and the rear guard and attach both
to the rear guard with 5/16-18 x 3/4 hex bolts
and nuts.
9. Tighten all hardware.
Mounting Cover Assembly
NOTE: Assistance from another person may
ease mounting the cover assembly to mower.
1. Lift and rotate the cover to align the cover
brackets with the support assembly tubes.
2. Move the cover down over the support tubes.
6 6
ASSEMBLY
Container Assembly
1. Remove the end caps (G) from the center
two bag support arms.
2. Fully insert the spacer plugs (H) into the ends
of the support tubes. It may be necessary to
tap the spacers into place with a hammer or
mallet.
3. Replace the end cap back over the spacer.
The additional extension will hold the hood
more tightly when latched.
4. Install the containers on the support frame,
overlapping containers at the center
supports.
5. Close the cover and lock the latch handles
over the center support tubes.
H
G