Indel B TB 12 BT Instructions D'utilisation page 19

OFF-SET VALUE
This is the information needed to align the temperature shown on the display with the actual
temperature inside the refrigerated compartment. Each offset can be adjusted within a range of
from -10 to +10.
After running the refrigerator for a few hours, place a digital thermometer inside the compartment
and check that the temperature shown on the display is the same as that indicated by the
thermometer. If the temperature is not the same, the off-sets must be adjusted in relation to the
temperature T you want the inside of the compartment to reach, so that the temperature reading
on the display coincides with the temperature indicated by the thermometer.
The following table shows the factory off-set setting for each temperature range and the
adjustment range for changing these settings.
OFF-SET FUNCTION
Set temperature ≥ 0 °C, temperature
F1
compensation value
-1 °C ≥ Set temperature ≥ - 14°C,
F2
temperature compensation value
Set temperature ≤ - 15°C, temperature
F3
compensation value
SETTING TEMPERATURE COMPENSATION
When the appliance is switched off press and hold both ∧ and ∨ buttons for 3 seconds, to enter into
the setting menu. Press "ON/OFF" button,to switch from battery protection mode to temperature
compensation (F1/F2/F3) settings, then press ∧ or ∨ to
set the related parameter settings.
FILLING
Do not put hot food items into the refrigerator. Place the products in such a way as to avoid them
hitting against each other or breaking because of the movement of the vehicle.
Make sure that the lid is always well closed and open it for as short a time as possible.
DEFROSTING
Defrosting is needed when the layer of frost is thicker than 4 mm. To carry out this operation, turn
off the refrigerator. Do not use sharp or cutting tools to remove the layer of frost or ice. Wait until
complete unfreezing and then turn on again.
VALUE DEFAULTED
RANGE
WHEN SHIPMENT
-10°C ~ +10 °C
-10 °C ~ +10 °C
-10 °C ~ +10 °C
17
0°C
0°C
1°C