Hendi 261309 Mode D'emploi page 8

Storage
• Always make sure the appliance has already
been disconnected from the electrical power out-
let and cool down completely.
Troubleshooting
If the appliance does function properly, please check the below table for the solution. If you are still unable to
solve the problem, please contact the supplier/service provider.
Problems
Neither the lamp indicator nor the
heating elements heat up.
When connected to the electrical
power supply, heating control is set &
the power indicator lights on. But the
appliance does not heat up.
When connected to the electrical
power supply, heating control is set
but the power indicator does not light
up. The appliance can still heat up.
Conveyor chain does not rotate (See
EN
below photo)
Gear or chain do not rotate
8
• Store the appliance in a cool, clean place.
Possible causes
The power plug is not connect-
ed firmly with the electrical
power outlet.
Thermal cut-out activated
Heating element is burnt out.
The power indicator is defective
Internal motor is defective
Control unit is defective
Gear or chain not in the correct
position
Possible solutions
Check the connection and
make sure all the connections
are correctly connected.
Contact with the supplier/ser-
vice provider for repair.
Contact with the supplier/ser-
vice provider for repair.
Contact with the supplier/ser-
vice provider for repair.