Installing The Water Dispenser Line - Samsung RF22KR Serie Mode D'emploi

INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20-125 psi (138 ~ 862 kPa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly filled. To do this, press the water dispenser
lever until the water runs from the water outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼" compression nut.
Connecting to the water supply line
1. First, shut off the main water supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Cold water line
Pipe clamp
Shut off valve
3. Connect the water line installation kit to the
shut off valve.
Cold water line
Pipe clamp
Shut off valve
RF22KR_DA68-02897B-00_EN.indd 15
Connecting the water supply line to
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing
• ¼" copper tubing
• ¼" compression nut
• Ferrule (2pc)
1. Connect the household water line to the
- If you are using copper tubing, slip the
- If you are using plastic tubing ( B ) , insert the
CAUTION
Water line installation kit
2. Tighten the compression nut ( A ) onto the
Use Plastic Tubing
• ¼" plastic tubing
→ Molded end(Bulb)
(1pc) • ¼" compression nut
(1pc)
Refrigerator
Compression
Nut (1/4")
(Assembled)
Ferrule
(Not supplied)
Copper tubing Plastic tubing (B)
or
(Not supplied)
(Not supplied)
Household water supply line
assembled compression fitting.
compression nut ( A ) (not supplied) and
ferrule (not supplied) on the copper tubing (not
supplied) as shown.
molded end (Bulb) of the plastic tubing ( B )
into the compression fitting.
Do not use without the molded end (Bulb)
of the plastic tubing ( B ).
compression fitting.
Do not over-tighten the compression nut ( A ).
Plastic Tubing
(Assembled)
Compression
Fitting
(Assembled)
Molded
end(Bulb)
Compression
nut (A) (1/4")
(Not supplied)
English 15
2015-12-18 3:27:29