Harbor Breeze C-FW60BNK3LR Mode D'emploi page 13

FINAL INSTALLATION
2. DANGER: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades (G). If
screws are overtightened, blades (G) may crack and break.
Place one blade plate (J) under blade (G), aligning holes.
Then, insert one motor screw/washer (BB) into one of the
holes at the end of the blade (G), turning until the motor
screw (BB) comes through the other side of the blade (G).
Repeat with the other motor screw/washer (BB).
Align the protruding ends of the motor screws/washers
(BB) with the corresponding holes on the underside of the
motor housing (D). Tighten both motor screws/washers
(BB). Repeat Step 2 for the other two blades (G).
DANGER: To reduce the risk of personal injury,
make sure all blades (G) are completely secure before
proceeding.
Hardware Used
BB
Blade Screw/Washer
3. Partially loosen two motor plate screws (O) in motor
plate on underside of motor housing (D) and remove the
other motor plate screw (O). Align slotted holes in fitter
plate (N) with loosened motor plate screws (O), allowing
molex connections from motor housing (D) to come
through hole in fitter plate (N). Twist fitter plate (N) to
lock. Re-insert the motor plate screw (O) that was
removed and securely tighten all three motor plate
screws (O).
4. Partially loosen two fitter plate screws (P) on the
underside of the fitter plate (N) and remove the other
fitter plate screw (P). Locate molex conections from
motor housing (D) and remove plastic that holds these
wires together.
2
x 6
3
Motor
Plate
Connections
4
N
Connections
13
S
BB
I O
Molex
I O
P
Molex
D
G
D
I N
D
P