Maintenance And Cleaning - Stanley SLB- 3IN1 Traduction De La Notice Originale

MAINTENANCE AND CLEANING

WARNING: When servicing, use only
identical replacement parts. Use of
any other parts may create a hazard or
cause product damage.
WARNING: Always wear eye protection
along with hearing protection.
Failure to do so could result in objects being
thrown into your eyes and other possible serious
injuries.
WARNING: Before inspecting, cleaning, or
servicing the machine, shut off engine, wait
for all moving parts to stop, and disconnect
spark plug wire and move it away from spark plug.
Failure to follow these instructions can result in
serious personal injury or property damage.
1). When the product is stopped for servicing,
inspection or storage, shut off the power source,
disconnect the spark plug connector from the
spark plug and make sure the product has come to
a complete stop. Allow the product to cool
before making any inspections, adjustments, etc.
2). Store the product where the fuel vapour will not
reach an open flame or spark. Always allow the
product to cool down before storing.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from
various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove
dirt, dust, lubricant, grease, etc.
WARNING: Do not at any time let brake
fluids, gasoline, petroleum-based
products, penetrating lubricants, etc., come
in con tact with plastic parts.
Chemicals can damage, weaken ordestroy plastic
which may result in serious personal injury.
You can often make adjustments and repairs
described here. For other repairs, have the blower
serviced an Authorized Service Center.
CLEANING THE AIR FILTER
For proper performance and long life, keep air filter
clean.
1. Remove the air filter cover by turning the dial
counter clockwise while gently pulling on the
cover. (Fig. 7)
2. Rinse filter with clean water.
3. Gently squeeze filter until excess water is
removed. Replace filter.
4. Place the air filter cover back on the unit. Turn
dial clockwise until cover is secure.
NOTE: The filter should be replaced annually for
best performance.
SPARK PLUG
This engine uses a TORCH, L8RTC or equivalent
spark plug with .025 in. electrode gap. Use an
exact replacement and replace annually, or more
frequently if necessary.
WARNING: Be careful not to cross-thread
the spark plug. Cross-threading will
seriously damage the product.
CLEANING THE EXHAUST PORT, MUFFLER AND
SPARK ARRESTOR
NOTE: Depending on the type of fuel used, the
type and amount of lubricant used, and/or your
operating conditions, the exhaust port, muffler, and/
or spark arrestor screen may become blocked with
carbon deposits. If you notice a power loss with
your gas powered tool, you may need to remove
these deposits to restore performance. We highly
recommend that only qualified service technicians
perform this service.
The spark arrestor must be cleaned or replaced
every 50 hours or yearly to ensure
proper performance of your product. Spark
arrestors may be in different locations
depending on the model purchased. Please contact
your nearest service dealer for the location of the
spark arrestor for your model.
13
G
B