Display Selection; Adjust [Settings] Mode Settings - Kenwood KDC-DAB41U Mode D'emploi

■
Press and hold DAB to cancel service list
update.
■
There is no DAB sound and no operation
can be performed while service list is
updating. It may take as long as three
minutes.

Display Selection

Press DISP repeatedly to select an
information.
SERVICE LABEL (Service label) ; DYNAMIC
LABEL (Dynamic label ) ; PTY LABEL (PTY
label ) ; ENSEMBLE (Ensemble label) ; DAB
LEVEL (Signal strength ; "LV STRONG": Good
; "LV WEAK": Bad ; "NO SIG": No signal) ; BIT
RATE (Transmission speed of the audio
service) ; FREQUENCY ; CLOCK
Item
Selects the tuning mode for 4 / ¢ buttons.
SEEK MODE
AUTO1 * Select an ensemble, service or component
AUTO2
MANUAL Select an ensemble, service or component
PRIORITY ON *: Switches automatically to FM and enables listening of same program when DAB signal strength becomes
weak. In DAB to FM case, the unit keeps DAB source. And it returns DAB sound when DAB reception becomes good
again. Also, when listening to FM, switches to DAB source if there is same program in DAB. ;
OFF: Cancels (Does not switch automatically).
DRC ON: Adjusts the dynamic range of the sound when the program has Dynamic Range Control (DRC). ;
OFF *: Does not adjust the dynamic range.
ASW SELECT Sets the interrupting announcement (page 10).
Turn the volume knob to select the announcement. Press the volume knob to turn on ("*" appears) or off.
• Exiting the interruption: Switch the setting of the interruption of the item being interrupted from permission to
prohibition.
• Set the displayed language with [LANGUAGE SEL]. (page 10)
DAB LIST UPDT AUTO *: Automatically updates the DAB service list when ACC is turned ON. ;
MANU: Updates the DAB service list when DAB button is pressed.
Selects the available Program Type (page 10). Then, press 4 / ¢ to start searching.
PTY SEARCH
• Set the displayed language with [LANGUAGE SEL]. (page 10)
PTY WATCH After registering a desired programme type, when the programme in the registered type starts in the Ensemble
being received, the Service is automatically switched.
PTY WATCH OFF: Cancels (does not change) ; Selects the available Program Type (page 10). (except SPEECH and
MUSIC)
• Set the displayed language with [LANGUAGE SEL]. (page 10)
Selectable setting (Preset: *)
Press 4 / ¢.
Search in the order of the services in the preset
memory.

Adjust [SETTINGS] mode settings

While listening to the service...
Press the volume knob to enter
1
[FUNCTION] mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to make a
3
selection, then press to confirm.
See table below for selection.
Hold to finish the procedure.
4
Press and hold 4 / ¢.
Automatically search for an ensemble.
–
Manually search for an ensemble.
Continued to next page
9
English