Handling and maintenance
• Allow the sunshade to dry when open to prevent the formation of
mould and discolouration.
• A protective sleeve protects the sunshade and will extend its ser-
vice life.
• Only pull the protective sleeve over the dry sunshade when it is dry.
• Clean the protective sleeve and the sunshade cover when needed
with lukewarm water and a sponge.
• Do not use any bleach or sharp objects, to avoid damage to the
cover.
• Check the tightness of all screws from time to time and tighten
them if necessary.
• If the sunshade is located in a highly exposed position, increased
wear and tear must be expected. In such cases we recommend
more intensive care and maintenance.
• In most cases, defective sunshades can be repaired by your
SUNCOMFORT/GLATZ partner. Only use original replacement
parts from SUNCOMFORT/GLATZ.
Disassembly
Disassemble the sunshade if it is not going to be used for a longer
period. WARNING! DANGER OF TIPPING. DANGER OF INJURY CAUSED
BY SUNSHADE TIPPING OVER.
1 Close the sunshade correctly and tie up.
2 Take the sunshade out of the base / of the ground socket and lay it
down.
3 Store the sunshade in a lying position along with all accessories in
a dry place.
EC Conformity declaration
We, Glatz AG, Neuhofstrasse 12, CH-8500 Frauenfeld,
SWITZERLAND, hereby declare that this product complies with the
directives of the European Community. The applicable declarations of
conformity can be found on our Download area at www.suncomfort.com.
40
41