Eaton Cooper Lighting IRiS P3LED09 Instructions D'installation page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation Instructions – P3LED09 Recessed Housing Platform
Special Instructions and Applications
The LED Mechanism is secured with a cable-tie for
N
otee:
shipping (Figure 12.). Cut and remove the cable-tie
prior to adjusting the mechanism.
LED Reflector Installation
To prevent damage to the LED Module, the LED Reflector
should not come in contact with the dome of the LED
Module. Do not touch the inside reflective surface of the
LED Reflector. Grasp the reflector via the outside surfaces.
1.
If installed, remove the LED Protective Cover from the
Reflector Retention Ring by turning counterclockwise
and then lifting off.
Cut and remove cable-tie
before attempting to adjust
mechanism.
Figure 12.
N
otee:
Please note that the below illustrations are for basic
installation instruction and the actual product may
appear slightly different.
Figure 13.
Position Reflector
Figure 15.
Lock
Larger attachment wing of
LED glass reflector goes to
larger opening marked with
larger rectangular block.
Figure 16.
Detailed View
4
Figure 14.
Turn
Installation Instructions – P3LED09 Recessed Housing Platform
0007354INS
ADI140849
2.
Position LED Reflector so that the larger attachment
wing aligns with the larger opening in the Reflector
Retention Ring. The larger opening is marked with a
solid rectangular block (Figure 13. and Figure 16.).
3.
Turn clockwise (Figure 14.) to engage and lock
(Figure 15.).
The LED Reflector is removed by turning counterclockwise
until the stop is reached, then pulling the LED Reflector off
of the Reflector Retention Ring (DO NOT FORCE).
Light Source Rotation
1.
Loosen the rotation lock down screw using a Phillips
No. 2 screwdriver (Figure 17 .).
2.
Turn the mechanism to the desired position using the
positioning tab and a screwdriver (Figure 18.).
3.
Tighten the rotation lock-down screw to secure the
desired position. (Do not over-torque). (Figure 17 .).
Light Source Tilting
The mechanism is set at 45 degrees tilt. If necessary,
tilt the mechanism by turning the tilting screw in the
clockwise direction (Figure 19.). Reference the angle dial
on the mechanism assembly for determining tilt angle. No
additional steps are required for locking the tilt position the
mechanism automatically locks into the desired position.
Cut and remove the cable-tie prior to adjusting the
N
otee:
mechanism (Figure 12).
Optical Element Installation
Installation of the optical element onto the housing platform
is performed after the housing platform is installed in the
ceiling, the aperture opening has been cut into the ceiling,
and the desired LED reflector has been installed. For proper
installation, please refer to the Installation Instruction sheet
provided for the optical element.
Figure 17.
Figure 19.
www.eaton.com
Figure 18.

Publicité

Table des Matières
loading

Table des Matières