Caloric CVU306C-SS Instructions D'installation page 13

RANGE HOOD OPERATIONS
Control Panel Layout and Buttons Configurations:
In addition to the remote-control feature, this range hood is also equipped with a heat sensor that will self-
calibrate in 5 seconds when the range hood is first electrically activated and beeps when self-calibration is
done. To conserve energy, the LCD panel will turn off automatically after 5 seconds of inactivity.
Adjusting Heat Sensitive Auto Speed (HSAS) Function:
•
Press Auto Function button to Turn On/Off the Auto Mode. The Auto Function Icon will appear in
the LCD Panel when Auto Mode is On.
•
While the range hood is off, press and hold Auto Function button to enter the temperature setting
mode. Press Increase or Decrease button to adjust the comparison temperature value between
the internal and external heat sensors from 8°F to 20°F. The temperature setting mode will exit
automatically after 5 seconds of inactivity.
•
While the range hood is off and Auto Function is activated, the blower will turn on to its highest
speed automatically when the internal temperature is 4 times above the external temperature.
Then it will adjust the speed level (between speed levels F4 to F1) automatically according to the
detected temperature between the sensors (4 times to 1 time). The speed level can also be
manually overwritten by press the Increase or Decrease button and Auto Function will reactivate
after 2 minutes. The blower can ONLY be turned off MANUALLY or activate the delay off timer
function.
Activating Normal Blower Function:
•
While the range hood is off, press Increase or Decrease button to start the blower. Press Increase
button to increase blower speed (F1 to F4) as indicated in LCD panel. The Increase button cycles
blower settings from off (00), quiet speed (F1), low speed (F2), medium speed (F3) to high speed
(F4).
•
While the range hood is on and the blower is running, press Decrease button to decrease blower
speed (F4 to F1) as indicated in LCD panel. The Decrease button cycle blower settings from high
speed (F4), to medium speed (F3), low speed (F2), quiet speed (F1) to off (00).
Activating Light Function:
•
Press Light button once to turn on the lights, and once again to turn off the lights.
CAUTION: DO NOT touch the lights until switched OFF and cooled.
Activating Power-Off Delay Function:
•
While the range hood is on and the blower is running, press Power-Off Delay button to activate
delay off timer and "Power-Off Delay" icon will appear in LCD panel. Adjust to desired period of
delay off timer by pressing Increase or Decrease button (minimum 1 minute to maximum 15
minutes). Timer begins to countdown immediately, when it reaches 0, the blower will shut off.
Adjusting Clock Function:
•
While the range hood is off, press Power-off Delay button once to enter the clock setting mode,
press Increase or Decrease button to set the Hour. Press the Power-off Delay button again to set
the Min. Press the Power-off Delay button again to exit the clock setting mode.