Caloric CVU306C-SS Instructions D'installation page 12

INSTALLATION
(continued)
Step 2:
For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For a more
secure installation, use as many mounting holes as needed to secure from the inside of hood.
Use an 8" round metal pipe (follow building codes in your area) to connect the exhaust on the hood
to the ductwork above, as illustrated in figure 4. Use duct tape to make all joints secure and airtight.
Step 3:
Step 4:
Turn power ON in control panel. Check all lights and fan operations.
Drop oil tunnel into recess support near rear of
hood. See figure 8.
8
Figure
9
Figure
To install baffle filters and stainless spacer(s), refer to
figure 9 and follow these five steps:
Angle filter toward back of
hood. Push filter up until
almost level.
Slide forward into recess behind the front of
hood. Lower filter.
Slide back until it fits into resting position.