Parts & Controls - General RLD382P Mode D'emploi

RLD382P Manual -6P-071008:RLD382P
DISABLE AUTO POWER OFF: Press and Hold "Hi" button then power on the
Warm-Up TIME: Approximately 45 seconds
Operating Temperature & Humidity: 32° to 104°F (0° to 40°C), < 80% RH
STORAGE TEMPERATURE & HUMIDITY:
14° to 140°F (-10° to 60°C), < 70% RH
ALTITUDE:
< 6500' (2000m)
OPERATING GUIDE:
1. The refrigerant leak detector unit is not equipped with anti-explosive
designs and measures. Do not use this unit in the environment with any
burnable gases
2. There are some environmental conditions that might cause error
readings:
• Pollutant places
• Large temperature variation
• Places with high wind velocity
• Organic solvent, adhesive vapor, fuel gas and vesicant will cause an
abnormal response from the sensor. Try to avoid environments affected
by these substances
• Places filled with too much Freon gas
PARTS & CONTROLS:
PANEL DESCRIPTION
1. Sensor Protector
2. Sensor
3. LED Leak Indicators
4. Sensitivity Lo Button
5. Sensitivity Hi Button
6. Reset Button
7. Low Battery Indicator
8. Power ON/OFF
9. Battery Cover
10. Battery Cover Screw
meter.
7/10/08 11:32 AM P