Triton T41200BS Instructions D'utilisation Et Consignes De Sécurité page 10

Troubleshooting
Problem
No function when On/Off Trigger Switch (10) is operated
Sander pulls to the side during operation
Belt sander running despite not touching the
On/Off Trigger Switch
GB
10
Possible cause
No power
Defective On/Off Trigger Switch
Off-centre sanding belt
Loose sanding belt
Lock-On Button (9) activated
Solution
Check power supply
Replace the On/Off Trigger at an authorised Triton
service centre
Adjust the belt Tracking Adjustment Knob (7) to align the
belt. If problem persists, refit the belt as instructed in 'Fitting
a sanding belt'
Ensure the Belt Tension Lever (15) is securely closed.
If problem persists, refit the belt as instructed in 'Fitting
a sanding belt'
To stop the machine, squeeze and release the
On/Off Trigger Switch