Connection 2 - Defender GK300-7M2 Manuel D'utilisation

WIRING INSTRUCTIONS
• Repeat the above steps using the brown wire and the monitor's negative camera connection (marked 2)
• Test that the wires are properly connected by lightly attempting to pull the wires away from the monitor.
They should not come disconnected.
Your camera and monitor will now be connected .
Connecting the Electric Doorstrike to Monitor (Doorstrike and Wiring not Included)
The GK300-7M2 does not come with an electric door strike (lock), if you would like to connect a door strike. The
door strike must run off an 8-16 VAC power supply to be compatible with the GK300-7M2.
If the two wires are not already connected to your doorstrike:
• Using the instruction manual provided with your door strike, connect the positive and negative wires to their
proper terminals on the doorstrike.
Connecting Doorstrike to Monitor
• Using a screwdriver or similar object push down on the small grey box above the doorstrike positive connec-
tion hole marked as 3.
• Insert the positive wire from the doorstrike into the positive doorstrike connection on the monitor (marked
3) and make sure it is completely inserted.
• Release the downwards pressure on the grey box and this should lock the wire into place.
• Pull lightly on the wire to make sure it is secure.
• Repeat the above steps for the negative wire and negative connection marked 4.
Your door strike should now be connected to the monitor.
Note: Connecting the GK300-7M2 to an electronic door strike (lock) is optional and is not required
for operation.

Connection 2

Modèle # GK300-7M2 Model # GK300-7M2
7