General Information; Troubleshooting - Defender GK300-7M2 Manuel D'utilisation

CAMERA OPERATION
Chroma:
Brightness:

GENERAL INFORMATION

1. To operate the camera, press and release the doorbell button on the camera.
2. The chime will ring on the inside monitor and the monitor screen will display the audio and video from
the camera.
3. To communicate from the monitor to the camera press and release the "Talk" button. Note: Audio from the
monitor will not be heard on the camera until the "Talk" button is pressed on the monitor.
4. Press and hold the "Unlock" button to trigger the electric doorstrike (IF INSTALLED) and allow the visitor to
enter. NOTE: A 12 V DC compatible electric door strike (not included) must be properly connected.
Automatic Monitor Time Out
The monitor will automatically stop displaying the audio/video at set intervals depending on the situation.
- If the doorbell is pressed and no other buttons are pressed the monitor will shut off after 55 seconds.
- If the view button is pressed the monitor will shut off after 40 seconds.
- If in view mode and the "Talk" button is pressed the communication and the monitor will stay on for
120 seconds.

TROUBLESHOOTING

No Picture/Signal
Picture too Bright/
Dark
No Audio
Modèle # GK300-7M2 Model # GK300-7M2
Adjusting the Chroma knob will allow you to adjust the intensity of the color in
the picture on the monitor. The higher you adjust, the more intense the color will be.
Adjusting the brightness will make the picture brighter or darker on the monitor. The
brighter it is where your camera is, the lower you should adjust the brightness.
• Make sure all the connections are secure and properly connected
• Make sure your monitor is plugged into a power source from the DC15V
adapter on the back of the monitor
• Make sure there is nothing obstructing the view of the camera
Note: that the camera will not appear on screen until someone presses the
doorbell or you press the view button yourself.
• The night vision comes on automatically when the light levels drop; try the
camera in a pitch black setting. The area that the camera is in may get too
much light to activate the sensor.
• Make sure the volume notch on the monitor is turned up and that nothing is
interfering with the speakers or microphone on the monitor, or the camera
• If the melody is not playing, make sure nothing is interfering with the speaker
and try adjusting the melody volume to a higher level
• Make sure whatever you are trying to hear is close enough to the microphone
on the camera/doorbell device
• Disconnect and reconnect the wires from the camera and the monitor to make
sure they are secure.
12