Camera Operation; Flat Surface Mount - Defender GK300-7M2 Manuel D'utilisation

CAMERA OPERATION

Flat surface mount

1. Lift up sticker located on the front of the camera on right side.
2. Completely remove the screw from the flat surface mount.
3. Remove camera from mount (it is held in by plastic tabs, you may have to apply some force to separate the
two pieces).
4. Locate a desired mounting location.
5. Screw in the mount in the desired area near the front entrance using the holes on the top and bottom of
the mount.
6. Reconnect the wires to the proper terminals (instructions above) and tighten the securing screws to secure
the wires to the back of the camera.
7. Put camera into the mount and insert the screw into the hole behind the sticker, tighten the screw to secure
camera to the mount.
8. Peel the paper off the back of the rest of the sticker in front and secure it over the screw hole.
Monitor - Front - From Left to Right
View: Allows you to view and hear outside without someone pressing the doorbell. This will display the
image from the camera as well as allow you to hear what the camera's audio picks up outside.
Unlock: If the camera or monitor is connected to an electric door strike, you can trigger the door strike by press
ing the unlock button. The door strike will remain triggered as long as you are pushing the unlock
button down. (Electric door strike is not included).
Talk: When someone presses the doorbell button on the camera or the monitor is in view mode, the hands
free 2-way audio communication can be initiated by pressing and releasing the talk button. To hang
up, press the talk button again.
Monitor - Side - From Left to Right
Melody:
L M H (Low, Medium, High):
Volume:
Modèle # GK300-7M2 Model # GK300-7M2
There are 8 different options for melodies to choose from. To change each
melody you must be in monitoring/view mode. While in view mode, press
the melody button to switch between the available melodies. Keep pressing
the melody button until the desired melody is played.
This switch controls the volume level of your melody. Setting the switch on 'L'
will make the melody volume low, on 'M' will make the melody volume
medium and on 'H' will make the melody volume high.
This volume knob controls the volume on monitor when listening to the
outside audio. THE VOLUME ON THE CAMERA (OUTSIDE) CANNOT BE ADJUSTED.
11