Laser Class; Maximum Radiation; Wave Length - Meister MKL 100 Manuel D'utilisation

6566030-Kreuzlinie-man 20.03.14 13:25 Seite 39
Specifications on the type plate
The type plate contains the following
information:
• Laser class 2 with a warning not to
look into the laser beam

• Maximum radiation

• Wave length

• Standard applied
• Type description
7 – Operating the cross line
laser
Laser safety
The cross line laser is of laser class 2
with a maximum performance of 1 mW
and a wave length of 650 nm. NEVER
LOOK INTO THE LASER BEAM.
IMPORTANT: Read all
instructions before starting to
operate this tool. Do not remove the
safety plates from the tool.
CAUTION: Do not use another
optical unit with this laser or
attach to this laser.
WARNING: Never look directly
into the laser beam as this
may be dangerous. Observe
all safety regulations as follows:
• Always wear laser protection goggles
(ordinary goggles are not sufficient).
• Use and maintain the laser in
accordance with the operating
instructions provided by the
manufacturer.
• Never point the beam at people or at
objects other than the work piece.
• The laser beam must always be
pointed at a stable work piece
without reflective surfaces, thus,
wood or a roughly coated surface are
permitted. Shiny, reflective steel sheet
or similar surfaces are unsuitable for
the use of lasers as the reflective
surface may reflect the laser beam
back onto the operator.
• The frame of the laser level should
not be replaced by that of another
type.
Repairs must be carried out by the
laser manufacturer or by an
authorised dealer.
• It is possible that the laser cannot be
seen in bright sunlight or on certain
types of surface.
• Always switch the laser off when it is
not in use or is left unattended.
• Always be careful with the laser: The
laser level is a precision instrument.
• Always keep the laser out of the
reach of children or pets.
• Never point the laser at other people.
• Always switch the laser off when it is
not in use or is left unattended.
Construction and setting
Open the battery
compartment and
insert the supplied
batteries. Make
sure the polarity
(+/–) is correct.
Always replace
used batteries in
pairs.
39