APLIC 302656 Mode D'emploi page 29

7 Buttons and functions
Mode button:
You can change between the different functions using the "MODE"
button.
Set button:
The values in the settings can be adjusted using the "SET" button or,
for example, by starting the built-in stopwatch.
Resetting:
Press and hold the "SET" button for 5 about seconds. "RESET" appears
on the display. This will then flash twice, and the corresponding value
is reset.
This function can be used only in the "Ride time (RIDETIME)",
"Distance covered (TRIPDIST)", "Maximum speed (MAXSPEED)" and
"Average speed (AVGSPEED)" modes.
Sleep mode
The bicycle computer starts the sleep mode (auto ON/OFF) if it does
not receive any signal after about 4 minutes. The current speed is not
displayed during the sleep mode.
As soon as the sensor inside the computer detects a movement, it
switches on automatically and receives data from the Reed sensor.
8 Replacing the batteries
Replace the batteries when the battery icon appears on the display or
the display becomes difficult to read. Before replacing the batteries,
ensure that (if desired) you note the total distance covered (TOT DIST)
and the total ride time (TOT TIME) because these values are reset
when the battery is replaced.
29
English