APLIC 302656 Mode D'emploi page 28

distance covered can be configured again in the startup settings when
the battery is replaced. Note the current reading before removing
the battery.
Total ride time (TOT TIME)
The entire ride time is shown here. The total ride time can be config-
ured again in the startup settings when the battery is replaced. Note
the current reading before removing the battery.
Memory (MEMORY)
Press the "SET" button in the memory mode to view the data of the
last 7 days. The date, distance, ride time, maximum speed, average
speed, etc are displayed. These values are shown one after the other
on the display. The data from the previous day is stored every day at
0:00 hrs.
Scan mode
The "scan" mode changes automatically every 4 seconds between
ride time (RTM), distance covered (DST), maximum speed (MXS), and
average speed (AVS).
6.1 Turning on the backlight
The "SET" and the "MODE" button has to be pressed at the same
time to turn the backlight on or off. Either EL ON (backlight switched
on) or EL OFF (backlight switched off) is shown in the display. If the
backlight is switched on, it glows each time for 3 seconds whenever
a button is pressed.
28
English