Removing The Unit - Kenwood DPX794BH Mode D'emploi

Installation/Connection
Installing in Toyota cars
(For / /
Install onto the car brackets using screws (E) or (F) (supplied). Use the
mounting holes ( ) or ( ) that fit the car brackets. Then, install the
supplied trim plate (C).
Do the required wiring.
(Page 38)
Dashboard of your car
* Only for illustration purpose.
)
Car bracket*
Installing the unit (without mounting sleeve)
Align the holes in the unit (on both sides) with the vehicle mounting
bracket and secure the unit with screws (supplied).
• For / /
and trim plate from the unit before installing.
(For / /
/ )
Use only the specified screws. Using wrong screws might damage
the unit.

Removing the unit

(For / /
1
Fit the catch pin on the extraction keys into the holes on both
sides of the trim plate, then pull it out.
2 Insert the extraction keys deeply into the slots on each side, then
follow the arrows as shown on the illustration.
: Remove the mounting sleeve
/
(For )
)
ENGLISH
37