Removing The Unit - Kenwood DPX500BT Guide De Démarrage Rapide

Removing the Unit

Removing the trim plate
1
Engage the catch pins on the extraction key
(Accessory 4) and remove the two locks on the
lower level.
Lower the frame and pull it forward as shown in
the figure.
Accessory 4
⁄
• The frame can be removed from the top side in the
same manner.
2
When the lower level is removed, remove the upper
two locations.
Catch
Lock
Removing the Unit
1
Remove the trim plate by referring to the removal
procedure in the section <Removing the trim
plate>.
2
Insert the two extraction keys (Accessory 4) deeply
into the slots on each side, as shown.
3
Lower the extraction key toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
¤
• Be careful to avoid injury from the catch pins on the
extraction key.
4
Pull the unit all the way out with your hands, being
careful not to drop it.
Accessory 4
English | 11