Pioneer PDA-5003 Mode D'emploi page 75

Selection will change as follows each time the SET
button is pressed:
3 RGB 3 COMPONENT1
COMPONENT22
The table below shows what settings are appropriate
and available for the type of connections made.
Set [SIGNAL FORMAT] and [COLOR DECODING] as follows.
Please take care when making settings. Incorrect settings
can adversely affect the plasma display.
SETUP
Connected
component
Component video output 525p
of a DVD player, etc.
Component video output 750p
from digital tuner, etc.
RGB video output of a 525p
video deck etc., with RGB
output
DVI video output of an AV 525p, 750p
component with DVI
output port (PDP-
505CMX/PDP-50MXE10/
PDP-50MXE11 only)
RGB video output of a PC VGA, WVGA,
720-PC,
XGA, WXGA,
SXGA, SXGA+
9
When the setup is completed, press MENU to exit
the menu screen.
Notes
÷ Set [SIGNAL FORMAT] and [COLOR DECODING] for each
applicable input (INPUT1, INPUT2 or INPUT5).
÷ The [COLOR DECODING] setting is not supported when
inputting a computer signal, or when the [SIGNAL FORMAT]
function has been used to select a signal other than [525p] or
[750p].
[CLAMP POSITION] setup
Depending on the signal, analog RGB signals may result
in the screen image appearing with a whitish or greenish
cast. In such cases, set [CLAMP POSITION] to [LOCKED].
Normally, leave this setting at [AUTO].
MENU
5/∞
2/3
SET
Display operating panel
SIGNAL COLOR
FORMAT DECODING
COMPONENT1
COMPONENT2
RGB
RGB
Not supported
MENU
2/3
SET
5/∞
Remote control unit
1
Press the MENU button to display the menu screen.
MENU
PICTURE SCREEN
:
CONTRAST
:
BRIGHTNESS
:
R.LEVEL
:
G.LEVEL
:
B.LEVEL
:
H.ENHANCE
:
V.ENHANCE
PICTURE RESET
ENTER
SET
2 Use the 2/3 buttons to select [SETUP].
MENU
PICTURE SCREEN
POWER MANAGEMENT
CLAMP POSITION
SIGNAL FORMAT
CHANGE
SET
3
Use the 5/∞ buttons to select [CLAMP POSITION].
MENU
PICTURE SCREEN
POWER MANAGEMENT
CLAMP POSITION
SIGNAL FORMAT
4
Press the SET button to select [LOCKED].
MENU
PICTURE SCREEN
POWER MANAGEMENT
CLAMP POSITION
SIGNAL FORMAT
The factory default setting is [AUTO].
Mode selection will change as follows each time the
SET button is pressed:
3 AUTO
LOCKED 2
5
When the setup is completed, press the MENU
button to exit the menu screen.
Notes
÷ Make this [CLAMP POSITION] setting for each applicable input
(PDA-5003: INPUT1 or INPUT5, PDA-5004: INPUT1).
÷ When using this setup, be sure to carefully check the signal
output of the component that you are using. For details, please
refer to the instruction manual supplied with the component
you are connecting.
System Settings
INPUT1
SETUP OPTION
0
0
0
0
0
0
0
EXIT
MENU
INPUT1
SETUP OPTION
:
OFF
:
AUTO
: : V G A
EXIT
MENU
INPUT1
SETUP OPTION
:
OFF
:
AUTO
:
V G A
INPUT1
SETUP OPTION
: OFF
:
LOCKED
:
V G A
21
En