HQ Power ARAS 170S VDPL170MH17 Mode D'emploi page 4

 Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 Mechanical wear and LEDs are not covered by warranty.
 A qualified technician shall install and service this device.
 Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
 This device is designed for professional use on stage, in discos, theatres, etc. The device shall only be used
indoors with an alternating current of 230 VAC, 50 Hz.
 Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
 Use the original packaging if the device is to be transported.
 Keep this manual for future reference.
4. Features
 with a high-power 170 W white LED
 DMX control via 17 channels
 7 rotating gobos (with shaking mode), 7 fixed gobos, 14 colours + white
 stand-alone mode with built-in programs, and music control function
 540° pan and 270° tilt
 high-speed electronic strobe function
 master dimmer function 0–100 %
 with rotating prism, iris, and auto focus
 clear display for easy configuration, 180° rotatable, with language selection, and auto switch-off after
15 seconds.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 carrying handles
2 LED indicators
3 display
4 control buttons
6. Installation
Choose a suitable mounting spot. Connect the power cord to the mains and switch on [6]. Switch off and
disconnect after use.
Mounting the Device
 Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
 The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
 The installation must always be secured with a secondary attachment e.g. a safety cable.
 Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
 Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
 Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
 For truss mounting, use appropriate clamps and brackets.
 Make sure there is no flammable material within a 0.5 m radius of the device.
 Have a qualified electrician carry out the electric connection.
 Connect the device to the mains with the power plug. All devices must be powered directly off a grounded
switched circuit and cannot be run off a rheostat or dimmer circuit, even if the rheostat or dimmer channel
is used solely for 0 % to 100 % switching.
V. 01 – 10/02/2014
VDPL170MH17
5 fuse holder
6 on/off switch
7 power input
8 power output
4
9 5-pin DMX output
10 3-pin DMX output
11 3-pin DMX input
12 5-pin DMX input
©Velleman nv