Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8476749
START UP
Hold the detector in a comfortable position,
and then rotate MODE to the desired position.
Mode settings are:
•
VLF (Very Low Frequency)
•
TR1 (transmit 1),
•
TR2 (transmit 2)
•
OFF
1.
Choose VLF Mode to adjust Tune
and Ground
•
Tune will allow you to adjust
the balance between receiver
and transmitter (see Tune the
Detector, Step 2).
•
Ground compensates for false
signals due to mineralized
soils (see Ground Step 3 b).
•
TR1 (Transmit 1) Allows you to detect extreme differences in metals, such as iron and
gold. Metals containing iron and gold will show on the analog meter.
•
TR2 (Transmit 2)-Allows you to detect finer distinctions between metals, such as
aluminum and gold (see Adjusting Discrimination Step 4).
2.
Tune the Detector
IMPORTANT! As you search, you can fine-tune the detector using the other controls. When the
detector senses a metallic object, the analog meter reads the changes and the detector sounds one
of three tones, depending on what metal is detected. The detector pitch tones vary according to the
strength of the find. Strong detections receive a higher pitched audio signal.
IMPORTANT! Press the red button on the handle at any time during the operation to automatically
return analog meter to its center point.
This step will fine-tune the balance between the detector's receiver and transmitter circuitry to provide
consistent pointer and tone indications. Follow these steps to tune the detector:
a.
Set Mode to VLF.
b.
Rotate Volume to the 10 o'clock position
c.
Set Ground, Discrimination, and Sensitivity to mid-range.
d.
Hold the search coil at least 10 in. (25cm) away from the ground and any metal object,
hold down the red button on the handle and slowly rotate TUNE until the analog meter
pointer resets at or near zero.
Visit www.princessauto.com for more information
Metal Detector
V 3.02
Fig.4
7
Publicité
Table des Matières
