Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8476749
4.
Unscrew the knobs on the search coil and remove the knobs and connector. Insert the
stem and align the holes on the search coil bracket and the stem. Push the connector stem
through the holes, then replace and tighten the knobs.
5.
Wind the search coil cable around the stem. Leave enough slack in the cable to let you adjust
the search coil when you are using the detector on uneven ground.
6.
Insert the search coil's plug into the jack on the control housing so that the pins on the plug
are aligned with the holes in the jack.
NOTICE! The Search Coil plug fits into the connector only one way. Do not force the plug
or you could damage it. To disconnect the search coil cable from the detector, grasp the
plug and pull it out of the connector. Never pull on the cable.
7.
Loosen the knob at the search coil end. Adjust the search coil to the desired angle. The
Search coil should be parallel to the ground. Tighten the knob. (Do not over tighten or use
tools to do this).
8.
Loosen the knob at the base of the handle, insert the arm support and tighten the knob.
BATTERY ASSEMBLY
NOTICE! If you do not plan to use the detector for 7
days or more, remove the batteries. Batteries can leak
chemicals that can destroy electronic parts. To extend the
life of your batteries, periodically switch the
two batteries.
IMPORTANT! Use only fresh batteries of the exact
recommended size and type.
This detector uses two 9 volt alkaline batteries
(not included) for power.
1.
Make sure detector mode has been turned to the
OFF position.
2.
Press the right battery compartment cover
tab and slide the cover off in the direction of
the arrow.
3.
Place a 9-volt battery into the compartment on top of the ribbon, matching the polarity
symbols inside.
4.
Replace the right battery compartment cover.
To insert second 9V battery on the Left
1.
Press the left battery compartment cover tab and slide the cover off in the direction of
the arrow.
2.
Place a 9-volt battery into the compartment on top of the ribbon, matching the polarity
symbols inside.
3.
Replace the left battery compartment cover.
Visit www.princessauto.com for more information
Metal Detector
V 3.02
Fig.2
5
Publicité
Table des Matières
