Sony BDV-IT1000ES Mode D'emploi

English
To stabilize S-AIR reception
Read the following when S-AIR reception is poor or unstable.
To use S-AIR products (S-AIR main unit and sub unit)
Before using S-AIR products, have the following ready.
• Confirm the wireless adapters are inserted
correctly.
Insert the wireless adapters firmly to the depth
into the slots of the S-AIR main unit and sub unit
respectively.
• Confirm that the S-AIR IDs of the S-AIR main unit
and sub unit are the same.
The default setting of the S-AIR IDs of the S-AIR
main unit and sub unit is "A."
Depending on the S-AIR product, you can set the
S-AIR ID by the switch or the setup menu.
For details, refer to the operating instructions of
each S-AIR product.
About environments where S-AIR products (S-AIR main unit and sub
unit) are used
S-AIR products use a radio frequency of 2.4 GHz. Certain electronic equipment or other factors may
cause lost connection or instability in S-AIR reception.
• Electronic equipment influence
The following may cause interference or cross talk.
– Cellular phones, cordless phones
– Wireless LAN, personal computers
– Game machines using radio signals
– Microwave ovens
• Other factors
The following may cause poor reception.
– Materials or structures, such as walls and floors
– The location where an S-AIR product is placed
When using S-AIR products, place them as far as possible from the above electronic equipment, or
place where S-AIR reception is stable.
©2008 Sony Corporation Printed in Malaysia
(1)
4-120-032-11(1)
Insert firmly
ID: A
A
B
C
S-AIR ID
A
B
C
S-AIR ID setup menu
S-AIR ID switch
When S-AIR reception is poor
Check the following.
Keep cords that are connected to the S-AIR product (AC power cord (mains lead), speaker cords, or
other cords) away from the wireless adapter and slot.
Keep as much space as possible around S-AIR products.
Avoid placing S-AIR products on top of, or directly below, other electronic equipment.
Avoid placing S-AIR products in a closed rack, metal rack, or under a table.
Adjust the location (height, orientation, and place in the room) of S-AIR products until reception is
the most stable.
Place so that the wireless adapters of the S-AIR main unit and sub unit are closer.
Place so that S-AIR products are separated from other wireless devices.
Place so that S-AIR products are separated from metal doors or tables.
If you cannot improve S-AIR reception, change the [S-AIR RF Change] / "RF CHANGE" setting. For
details, refer to the operating instructions of each S-AIR product.