Accessories - Leister GROOVER Instructions D'utilisation

Operation
• Connect tool to rated voltage.
• Cutting speed switch (4) set to position 1 or position 2 depend from material thickness.
• Hold the GROOVER by the handle (5) (left hand) and by the hand rest (6) (right hand).
• Align the marking arrows on the tool (red) with the grooving line. The adjustable guide roller (9) should run
inside the grooving line and the rear roller (10) in the groove.
• Activate the locking button(3). Switch on the operating switch (2).
• Press the handle down to the magnet stop (grooving position).
• The GROOVER is easy to push forward and straight along the grooving line with the adjustable guide roller (9)
and the rear roller (10).
• At the end of the groove, switch off the operating switch (2) and release the handle (5). The tool will spring back
into the starting position.
Caution: The cutting blade run out !
• If required set the guide roller (9) with the locking screw (21) and adjustment screw (20) (grooving centre).
Changing the cutting blade
Caution: Unplug the tool !
•
• Remove the cutting blade cover (14).
• Remove the blade with a box spanner.
• Clean the hub of the tool as well as the cutting blade to be inserted.
• Insert and fit the cutting blade. Check that the cutting blade revolves freely.
• Refit the cutting blade cover (14).

Accessories

• The Leister GROOVER is fitted with a tungsten carbide tipped cutting blade
• Only Leister tungsten carbide cutting blades should be used
• Only perforated blades should be fitted to the GROOVER, otherwise the suction pressure is too low
Illustration Order
not to scale number
102.401
102.402
102.404
Tungsten carbide tipped
blade ∅ 110 × 3.5 mm,
trapezium profile
Tungsten carbide tipped
blade ∅ 110 × 4 mm,
round profile
Tungsten carbide tipped
blade ∅ 110 × 2.5 mm,
round profile
Illustration Order
not to scale number
102.403
102.405
102.406
Tungsten carbide tipped
blade ∅ 110 × 2.8 mm,
round profile
Tungsten carbide tipped
blader ∅ 110 × 3.5 mm,
round profile
Diamond cutting blade
∅ 110 × 3.5 mm,
semi-round profile
13