Kinderkraft SOFI Guide D'utilisation page 15

•
To prevent injury from falls, if the child is able to climb out of the cot, the cot shall no longer be used
for that child.
Additional warning for the BABY COT function:
WARNING
•
Do not use more than one mattress in the cot.
•
Only use the mattress sold with this cot, do not add a second mattress on this one, suffocation
hazards.
•
The lowest position of the base is the safest. When the child starts sit alone is advised to use only
this base level.
•
If you leave the child in the cot unattended, always check, if the side entrance is fastened with a zip.
Additional warning for the PLAY PEN function:
•
WARNING Do not place the playpen close to an open fire or other heat source.
•
WARNING Do not use the playpen without the base/mattress.
•
WARNING Ensure that the playpen is fully erected and all the locking mechanisms engaged
before placing your child in this playpen.
•
The bottom of the pen must be mounted at the lowest level.
•
The playpen is designed for children up to 36 months weighing up to 15 kg.
1. LIST OF TRAVEL COT ELEMENTS:
A. Cot frame with the cover
B. Mattress
C. Bag
2. ASSEMBLY:
Undo the zip fastener on the bag (C) and remove the baby cot (FIG. 1). To unfold the baby cot grasp the
frame (A) on both sides, and then pull it up until the supports are unfolded (Fig. 2). NOTE! To ensure safety,
make sure that the supports are unfolded properly and locked. If the mattress (B) is not fastened, it should
be fixed inside the cot using the zip fastener (FIGS. 3, 4 and 5) and secured with a clamp (FIG. 6). To fold
the cot, it should be turned in such a way that the supports face up (FIG. 7). Pull one support holding the
frame with your leg (FIG. 8), and then lower it down inside the cot (FIGS. 9 and 10). Repeat the same
operation for the other support (FIG. 11).
3. TRAVEL COT FUNCTIONS:
Rocking function: The baby cot has a rocking function. To use it, slightly raise the baby cot on one side
(FIG. 12), and then unlock the rockers turning them out (FIGS. 13 and 14). Repeat the same operation with
the other rocker. NOTE! While unlocking the rockers, the child cannot be placed inside the baby cot!
Base adjustment: The baby cot has base height adjustment. To lower the base unclip the zip fastener fixing
clamp and open the zip fastener inside the baby cot (FIG. 15). Place the mattress inside the cot in the
bottom position (FIG. 16). NOTE: Under the mattress there are belts that should be put through the holes
at the bottom of the cot (I) and then attached to the hook and loop fasteners located under the cot (II)
(FIG. 17). When the mattress is at the lowest level, you can use the side entrance by undoing the zip
fastener (FIG. 18). NOTE! In the baby cot function the upper mattress position is designed for children who
cannot yet sit up alone. In the playpen function, the mattress must always be in the lowest position.
4. MAINTENANCE AND CLAINING:
Travel cot cover - wipe clean with a mild soap and water. Never clean with abrasive, ammonia based,
bleach based or spirit type cleaners. The travel cot must be dried thoroughly before use or storage.
15