Cleaning And Maintenance; Accessories/Spare Parts - Stihl ADVANCE ProCOM Instructions D'entretien

16.2 Factory Reset
Please see "15.8 Factory Reset" on page 20.

17. CLEANING AND MAINTENANCE

1. Check the ear cushions before wearing and clean
regularly with a damp cloth, special non-alcohol PPE
wipes for ear cushions or water with mild soap.
NOTE: The product may be adversely affected or damaged
by certain chemical substances (e.g. cleaning solvents,
toxic chemicals, strong detergents, or STIHL Varioclean).
Contact the manufacturer for further information. Make
sure that the cleaning agent used is compatible with the
skin.
• Do not submerge the product in water.
• Keep the product away from the water. Do not spill water or
beverages on the product or let it fall into water, such as the
ocean or a river.
• Do not splash water on the product, wash it with a high
pressure water hose, or soak the product in the water basin.
Doing so may damage the product.
• Do not clean the product with sharp or conductive objects,
such as nails, screwdrivers, or wire brushes.
• Do not clean the product with compressed air. Doing so may
damage the product.
2. Check the ear cushions regularly for wear and change
the ear cushions if necessary. The hygiene set should be
changed at least 2 times a year.
• If the cushions become hard, damaged, or otherwise
deteriorate, and the microphone becomes damaged or
deteriorated, they should be replaced promptly (contact STIHL
or your authorised dealer for exact replacement parts). The
ear cup cushions on the ADVANCE ProCOM earmuffs can be
replaced with new cushions from the Hygiene Kits listed below
(see instructions in 18.1).
NOTE: When reassembling the product after cleaning or
maintenance, ensure that the product is firmly assembled.

18. ACCESSORIES/SPARE PARTS

Spare Part
Hygiene Kit
Microphone
18.1 Removing and Replacing the Ear Cushions
(Q:1) To remove the ear cushion, slide your fingers under the
inside edge of the ear cushion and firmly pull straight out.
(Q:2) Fit one side of the ear cushion into the groove of the
ear cup and then press on the opposite side until the ear
cushion snaps in place.
Part Number
0000-889-9047
0000-889-9048
21
19. DISPOSAL
WEEE (Waste Electrical and Electronic Equipment)
The crossed-out wheel bin symbol on the product,
literature, or packaging reminds you that all
electrical and electronic products, batteries, and
accumulators must be taken to separate collection
at the end of their working life. To prevent possible harm to
the environment or human health from uncontrolled waste
disposal, please do not dispose of these products as
unsorted municipal waste, but hand it in at an official
collection point for recycling. Do not dispose of the product
with household waste. Disposal of the product should be
done via a STIHL dealer or public disposal centers.
20. TRANSPORTATION
Secure the product while transporting it. Otherwise, it may
damage the product.
• Do not transport, use, or store the product in temperatures
that are over the specified ambient temperature range to the
extreme. Doing so may reduce the lifespan of the electronic
device, damage the battery, and/or melt the plastic parts of
the product.
• Do not transport or keep the DC power charging and
firmware upgrade port or microphone port open. Cover the
USB port with a rubber cover or connect the microphone.
• If you wear hearing protection while driving or walking
in public, be sure to use the ambient listening function.
Otherwise, you may not hear safety alarms or ambient sounds,
which may lead to severe personal injury.
21. STORAGE
The product should be stored at room temperature.
• Do not expose the product to extremely high or low
temperature as this may reduce the life span of electronic
devices, damage the battery, and/or melt plastic parts of the
product.
• Do not store the product in humid environments, especially
for long periods of time. It may damage the internal electronic
circuits.
• Do not store the product in places colder or hotter than the
specified temperature.
• Do not store the product in dangerous areas, such as areas
with high electricity, electrical or magnetic fields, projectiles,
accelerated stones, or other flying debris.
• Do not store the product in environments that are corrosive,
electrical, or containing acrid fumes.
GB