InnoCigs RIFTCORE DUO Manuel D'utilisation page 50

INNOCIGS RIFTCORE DUO – USING THE DEVICE
Inserting the Cotton
1. Unscrew the clearomizer from the battery / box mod of your e-cigarette.
2. Connect the atomizer base to your battery / box.
3. Before inserting the cotton, press the fire button for three seconds after adjusting an output power of
30 watts.
4. Wait approx. 10 seconds for the RFC heaters to cool down.
5. Repeat this process a few times. This is done to clean the RFC heaters.
6. When the RFC heaters are cleaned, remove the clearomizer from the battery / box mod of your
e-cigarette.
7. Use tweezers to place two stripes of cotton between the RFC heaters. The cotton you find in the scope
of delivery is tailored. If you want to use your own cotton, cut it to the dimensions of 5 to 18 mm. Make
sure that the cotton does not overhang the edge of the atomizer base.
8. Drip a few drops of e-liquid directly into the cotton to make it fully saturated before first use.
48