Brizo MultiChoice 60 Serie Manuel Du Propriétaire page 7

Masquer les pouces Voir aussi pour MultiChoice 60 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3
Siderna
®
E.
12
Place the center hole of the escutcheon (12)
over the trim sleeve and carefully push it back to
the mounting plates (10). Magnets on the back
of the escutcheon will keep it in place.
Installation and Adjustment of the Temperature Knob
4
Failure to do so may cause injury.
2
1
5
6
Adjust temperature limit stop! Turn on water
supplies; let the water run at both full hot and
full cold to ensure the water is running as hot/
cold as possible. Place a thermometer in a
plastic tumbler, and hold the tumbler in the
water stream. Place the temperature knob (1)
onto the splines (2), then rotate the temperature
knob counter-clockwise until you achieve your
maximum desired temperature from the outlet
(not more than 120° or the lower temperature
mandated by your local plumbing code).
If max temperature is not achieved before limit
stop (3) on temperature knob (1) meets the
limit stop (4) on the volume control handle.
Remove the temperature control knob (1)
from splines (2). Rotate temperature control
knob (1) clockwise. Place temperature control
Valve Trim Installation (T60080, T60280 & T60480)
10
4
Siderna
13
12
60 Series Installation
F.
13
15
Place volume control handle (13) over valve
stem (14) and onto the trim sleeve (5). Lever
should point horizontally to 3 o'clock position.
Secure handle with set screw (15).
®
10
14
11
knob (1) back onto splines (2) and continue
to rotate counter-clockwise until maximum
desired temperature is achieved.Remove the
temperature knob (1) and replace onto the
splines (2), making sure that the temperature
knob limit stop (3) hits against the volume
handle limit stop (4) as shown. Secure the
temperature knob using screw (5) and place cap
(6) on knob.
®
For Siderna
temperature handle (knob) (10) onto valve stem
and secure with screw (11). Ensure O-ring (12) is
assembled on handle cap (13). Install handle cap
by pressing it into place on top of the temperature
handle (10). Secure cap by tightening screw (14)
from the underside of the handle.
7
5
14
(series T60X80) models, place
93648 Rev. B
4
3
1

Publicité

Table des Matières
loading

Table des Matières