Chapter -5: Door Reversal; Repositioning The Door; Chapter -6: Troubleshooting - Sharp SJ-TA35CHDIE-EU Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39

CHAPTER -5: DOOR REVERSAL

Repositioning the door

• It depends on which fridge freezer you have as to whether it is possible the reverse the doors.
• It is not possible where handles are attached at the front of the appliance.
• If your model does not have handles it is possible to reverse the doors, but this needs to be completed by
authorised personnel. Please call Sharp service.

CHAPTER -6: TROUBLESHOOTING

Check Warnings;
Your fridge warns you if the temperatures for cooler and freezer are in improper levels or when a problem occurs in the
appliance. Warning codes are displayed in the Freezer and Cooler Indicators.
ERROR TYPE
E01
E02
E03
E06
E07
E08
E09
MEANING
Sensor warning
Sensor warning
Sensor warning
Sensor warning
Sensor warning
Low Voltage Warning
Freezer compartment
is not cold enough
WHY
Power supply to the device
has dropped to below
170W.
Likely to occur after long
term power failure.
EN -15-
WHAT TO DO
Contact the Sharp help desk as
soon as possible.
Contact the Sharp help desk as
soon as possible.
Contact the Sharp help desk as
soon as possible.
Contact the Sharp help desk as
soon as possible.
Contact the Sharp help desk as
soon as possible.
- This is not a device failure, this
error helps to prevent damages
to the compressor.
- The voltage needs to be
increased back to required
levels
If this warning continues, contact
the Sharp help desk as soon as
possible.
1. Set the freezer temperature
to a colder value or set Super
Freeze. This should remove
the error code once the
required temperature has been
reached. Keep doors closed
to improve time taken to reach
the correct temperature.
2. Remove any products which
have thawed/defrosted during
this error. They can be used
within a short period of time.
3. Do not add any fresh produce
to the freezer compartment
until the correct temperature
has been reached and the
error is no longer.
If this warning continues, contact
the Sharp help desk as soon as
possible.

Publicité

Table des Matières
loading

Table des Matières