How To Use; After Use; Maintenance And Cleaning - Princess 332733 Mode D'emploi

3. Release Container Lock and insert Water Container. When in place, close Container Lock by foot.
To detach the Water Container for refilling, switch off the unit, unplug, and just pull up the lock using
your foot again. Handle can be used is used to carryfor carrying the Water Container, not the whole
unit. (See Figure 4)
4. Insert hose (02) into the hose adapter (03), press to fasten the hose until you hear a click. Pull gently to
make sure the hose is in position. (See figure 5)
5. The steamer is ready for use.

HOW TO USE

1. Plug into a proper voltage outlet, activateuate Power Switch by hand or foot to ON position as described
in Figure 6. (Power Indicator will light up).
Do not switch the steamer on if there is no water in the Water Container because it may get overheated.
Wait 2 to 3 minutes for steam to come out.
Note: It is normal to hear a gurglinges sound from the steamer while the heater starts to make creating
the steam or ifdue to condensation forms. If If thisit occurs during operation, just positionstraight the
Steam Head upwards to allow the excess of condensation to drain back into steamer.
2. Hold allany kinds of shirts, jackets, cardigans, pullovers, up by their etc. by its regular coat hangers. .
A trouser hanger is recommended for steaming trousers , and ties.
3. Then hold hold the clothing item in place usingit in the appropriate rod located in the Hanger Head.
4. Steam with a downward motion to avoid your hand coming into contactto get in touch with the steam,
as described in Figure 7. Use the other hand to straighten the area to be steamed and use yourthe
fingers to widen the area.
5. Steam slowly by touching material lightly with Steaming Head and wrinkles will vanish instantly.
It is very important to combine the touch of the Steaming Head withand direct steam. Some clothing
itemsarticles can be steamed better from the underside. Speed and efficiency can be is achieved with a
through little practice. (See Figure 8)
NOTE: Steam with Hose in an upright position, so any condensation is free to flow back into steamer.
If steaming in a low position near floor i.e. steaming under 1m, straighten Hose up and out FREQUENTLY
to keep clear of condensation.
Do not touch silk or velvet with the steam head.
DO NOT ALLOW STEAMER TO RUN DRY

AFTER USE

1. After using the steamer, switch to OFF (Power Indicator light will go outwill light off) and disconnect
the Power Cord from the outlet.
2. Hang the Steam Head in an upright position in Hose Hanger Rod when not in use.
3. Pour out the water each time after use. This is important as microorganisms may be able to grow in the
water and could damage the unit.
Therefore, regular replacement of the water is necessary.
WARNING:
1. Never touch the Steam Head until it cools completely
2. Never operate without water.
3. Unplug after each use.
4. Do not use the Water Container Handle to carry the whole unit, as the steamer may tip overbe turn over.

MAINTENANCE AND CLEANING

• Always unplug before cleaning the unit
• Let the steamer cool down and then use a damp clothe for cleaning.
• Never use harsh or abrasive cleaning agents or solvents
Cleaning the Water Container:
This is to be done regularly to prevent the growth growing of microorganism inside the
Water Container.
1. Unplug and pull up Container Lock to detach the Water Container.
2. Pour old water out if it has not been used for a period of time.
3. Refill water to the Water Container and then pour the water it out.
From time to time, and depending on the quality of your water supplier, the Water
Container has to be disinfected. Proceed as follows:
1. Unplug and pull up Container Lock to detach the Water Container.
10