ResMed AirFit N20 Guide D'utilisation page 12

Daily/After each use:
Before cleaning, take the mask components apart according to the
disassembly instructions.
1. Soak and agitate the cushion, elbow and short tube in warm water
(approximately 86°F/30°C) using a mild liquid detergent for up to
10 minutes.
2. Clean the components with a soft bristle brush, paying particular
attention to the small vent holes on the elbow.
3. Thoroughly rinse the components under warm flowing drinking quality
water.
4. Inspect each component to ensure that they are visually clean and
free of detergent residue. If required, repeat washing.
5. Allow the components to dry out of direct sunlight before assembling.
Weekly:
The magnetic clips can be left on for washing.
1. Soak and agitate the separated headgear and frame in warm water
(approximately 86°F/30°C) using a mild liquid detergent for up to
10 minutes.
2. To rinse the components, repeatedly squeeze them under warm
flowing drinking quality water until it is free of detergent residue.
3. Squeeze the components to remove excess water.
4. Allow the components to dry out of direct sunlight before assembling.
Reprocessing the mask between patients
Only Sleep Lab Mask (SLM) variants of the mask are intended for
multi-patient re-use. When using between patients, these masks must be
reprocessed according to cleaning and disinfection instructions available
on ResMed.com/downloads/masks.
6